(RGB) LED Steampunk Table Clock Showing Time with Colours Rainbow and Binary modes (USB cable included)

This is a high precision LED clock that shows time using colours. Just connect it to your computer! (USB cable included) ★The clock is hand soldered using SMD (Surface Mount Device) soldering. Normally, it is done made machines, so soldering SMD by hand is extremely challenging. ★ Showing time using colours The clock shows time from left to right in the following order: ○○hours○○minutes○○seconds　 Correspondence between the colours and the numbers: 0: Whitish blue　 1: Red　 2: Orange　 3: Yellow　 4:Green　 5: Aquamarine　 6: Skyblue　 7: Blue　 8: Violet　 9: Pink ★Binary mode Put the clock upside down to enjoy the binary mode and challenge your counting skills. Violet is used to display hours, sky blue - minutes. Every LED from left to right has a numeric value: 32 16　 8 4　 2 1　 Add the values of the glowing lights to understand the time. For example, on the photo with violet lights glowing: 16+4+1=21 hours　　 on the photo of the sky blue lights glowing: 16+2+1=19 minutes　　 So it was 21:19 when the photo was taken. When the time is 00 for hours or minutes, lights do not glow. So at 00:00 no light will glow. ★Room temperature display　（±3°C ） ★USB and a tablet battery included The clock works fine without any battery just if you simply connect it to your computer with a USB cable. But note that when disconnected all the settings will reset to default. Using a battery avoids such a reset. The clock will preserve the settings even if disconnected from power. The clock does not run on battery! ★Other features: DS3231 chip cool mercury switch cool brass spacers cool steampunk look touch buttons the brightness has to levels and auto-adjusts according to the brightness in the room chime alarm an ability to insert a message card under the top plastic screen Please, check the full description on our website. In the box: clock x 1　 USB cable x 1　 battery CR1220 (is already inside the clock) x1 user manual x1 　 Colour of wood is chosen randomly. Warnings: ✔The item is fully handmade. All electronic components are soldered to a circuit board by hand. Please, be sure to use with a lot of care. ✔ We design the final look, solder and finish the clock in Kyoto, Japan. We use Japanese cedar wood for wooden parts. ✔ Colour of the screws and spacers may slightly change depending on availability. ✔ All the settings set up is done by a mercury switch. It may be slow at times. Please, be patient and try again after some time.